Install internal USB devices
The product has two internal USB ports.
| 1.
|
| Turn the product off and disconnect the power cord.
|
|
| 2.
|
| Disconnect all interface cables.
|
|
| 3.
|
| Remove the right-side panel by sliding it towards the rear of the product to unlatch it.
|
|
| 4.
|
| Open the access door by pulling on the metal tab.
|
|
| 5.
|
| Locate the USB ports near the bottom of the formatter board. Insert the USB device into one of the ports.
|
|
| 6.
|
| Close the access door, and press firmly until it snaps into place.
|
|
| 7.
|
| Reinstall the right-side panel. Align the tabs on the panel with the slots in the product, and push the panel toward the front of the product until it latches into place.
|
|
| 8.
|
| Reconnect the interface cables and the power cord.
|
|
| 9.
|
|
HP Laserjet P4010 P4510 Install internal USB devices