Manually configure IPv6 TCP/IP parameters from the control panel
In addition to using the embedded Web server, you can also use the control-panel menus to set an IPv6 address.
| 1.
|
Press Menu  .
|
|
| 2.
|
Press the down arrow  to highlight CONFIGURE DEVICE, and then press OK.
|
|
| 3.
|
| Press the down arrow to highlight I/O, and then press OK.
|
|
| 4.
|
| Press the down arrow to highlight EMBEDDED JETDIRECT MENU, and then press OK.
|
|
| 5.
|
| Press the down arrow to highlight TCP/IP, and then press OK.
|
|
| 6.
|
| Press the down arrow to highlight IPV6 SETTINGS, and then press OK.
|
|
| 7.
|
| Press the down arrow to highlight ADDRESS, and then press OK.
|
|
| 8.
|
| Press the down arrow to highlight MANUAL SETTINGS, and then press OK.
|
|
| 9.
|
| Press the down arrow to highlight ENABLE, and then press OK.
|
|
| 10.
|
| Press the down arrow to highlight ADDRESS, and then press OK.
|
|
| 11.
|
Use the numeric keypad, or press the up arrow  or the down arrow to enter the address. Press OK.
|
| NOTE:
|
If you are using the arrow buttons, you must press OK after entering each digit.
|
|
| 12.
|
| Press Menu to return to the Ready state.
|
|
HP Laserjet P4010 P4510 Manually configure IPv6 TCP/IP parameters from the control panel